AA Power board plugs The ATmega is pre-flashed with

The ATmega is pre-flashed with the OptiBoot loader (compatible with the Arduino Uno) and the RF12demo sketch

USB Instructions and Schematic

The older Arduino Deicimila / Duemilanove bootloader works fine with the logic level pin floating (VCCIO - pin 4 on the FTDI chip)

and is designed 100% for through-hole components

chose the JeeLink 433 NoCase option - this is supplied without the clear plastic case

AA Power board plugs The ATmega is pre-flashed withGet clean 3. 3V regulated power from a single AA battery! The AA Power board is a neat board for generating 3. 3V from a single AA battery (Alkaline or NiMh), sufficient to power a JeeNode, for example. The board uses a wide input range LTC3525 boost regulator chip which draws only 7.. 30 A of current in idle mode (depending on input voltage). The input can be anything from 1. 0 to 5. 5V, so this can also be used with 2x or 3x AA battery packs (even